Tired of looking at that nasty cup holder you’ve never cleaned? Just cover it up!

Made of 3D printed ABS composite, textured front surface. The panel can only be installed with the pull tab in the back. It will not fit R models that already have a sliding door.

We offer these with or without the CJM logo on the front. Why is the blank one more expensive? – Branding. We don’t run ads, labeling our products helps promote our company. If we ran ad’s you’d be paying for it in the product cost.

Disclaimers:

• This part uses the spring loading cup holder tabs to lock into place. Therefore, it rubs on that surface and will scuff the gloss black finish on those tabs inside the cup holder. If that will upset you, do not order this part (see image).
• The single/half cup cover reduces the diameter of the front cup holder to 70mm/2.75″ and holds the centering tabs in their retracted position. Some bottles you previously used may not fit with this part.

Each order comes with:

• 1 – Panel with tab color of choice
• CJM Sticker